Create a line forming a circle by defining the centre point and radius.
- A centre point.
- The radius of the circle.
{1} is the radius of the circle.
Control Code Definition
A control code action Circle by Centre is assigned the value '{0=CircCentRad} {1}'.
Measured Points
Point 5 is assigned the code 'Pit CirCentRad 10', where '10' is the radius of the pit.
- Creates a 2 dimensional (circular arc) that starts and ends at the same pt.
- The height of the start and end points is the same as the centre point.
- You can input the radius, in the code or as an attribute, depending on the definition in Edit Control Codes. When using Leica freecodes the radius must be input as an attribute of the freecode.
