Availability: |
Computations module. |
Menu Selection: |
From the Computations task, select the Create/Point command
and the Method/Number of Chords command.
|
Functionality: |
Creates new
around an arc or circle based on a specified number of chords.
|
Controls: |
|
Actions: |
- The OK Button creates the new points.
-
The new point identifier may also be determined
by using the
or buttons.
|
Notes: |
-
To create points around a circle, enter the same point
identifier for both Radial Points.
-
The Elevation Drop Down will only be available
if the elevation attribute is active.
-
If the
elevation difference
control is selected from the Elevation Drop Down, the elevation
difference entered will be applied to each new point progressively.
-
The points created will be given the attributes
of the currently defined
point
attribute
.
-
The number of chords entered is one greater
than the number of new points created.
-
The new points will be created at equal chord
distances from the start of the arc/circle.
-
The identifier in the point identifier field
will be used for the first new point, and any subsequent new points
will automatically use the next unused point identifier.
|