Create Point from 2 Points & RadiusCentre Point from 2 Points & Radius

Availability: Computations module.
Menu Selection: From the Computations task, select the Create/Point command and the Method/2 Points & Radius command.
Functionality: new point
Controls:
Actions:
  • The OK Button creates the new point.
  • Next
Notes:
  • The Elevation Control will only be available if the elevation attribute is active.
  • There are always two possible solutions for this algorithm, depending on which side of the radial points that the centre point is to be located. After OK Button is pressed, a further dialog box will be displayed and one of the solutions highlighted. Use the Reject button to toggle the highlight between the alternate solutions. Use the Accept button to create the currently highlighted solution.