Used to set distance rounding types 1, 2 and 3.
The dialog box is displayed after selecting the Configure/Distances command and then selecting the appropriate rounding button in the Distance Configuration dialog box.
The options available in the Distance Rounding dialog box will depend on the distance unit type (Metres, feet, links) selected in the Configure/Units command.
Distances Below
Enter the distance ranges for which the corresponding rounding settings are to be applied.
Rounded To
Select the rounding to be used for the corresponding distance ranges.
The default rounding entered will be used for any ranges not specified.
Trailing Zeroes
Set whether rounded distances should display any unnecessary zeroes following the decimal point.
Trailing zeroes are displayed if the check box is active. For example if the check box is not active
then 123.400 would display as 123.4
Show Decimal
Set whether the decimal point is to be shown for rounded distances which are a whole number of units
and have trailing zeroes not shown.
The decimal point is displayed if the check box is active. For example if the check box is not active,
then 123.000 would display as 123
OK
Save any changes made and return operation to the Configure Distances dialog box.
The changes may still be cancelled by selecting Cancel in the Configure Distances dialog box.
Cancel
Close the dialog box without saving any changes and return operation to the Configure Distances dialog box.
Refer to the Distance Rounding topic for further assistance and an example of how the rounding is applied.