This functionality is available with the Computations, Volumes and Profiles & Design Modules.
Used to set area rounding types 1, 2 and 3.
The dialog box is displayed after selecting the Configure/Areas command and then selecting the appropriate rounding button in the Area Configuration dialog box.
The options available in the Area Rounding dialog box will depend on the area unit type (Hectares, Acres) selected in the Configure/Units command.
Areas Below
Enter the area ranges for which the corresponding rounding settings are to be applied.
Rounded To
Select the rounding to be used for the corresponding area ranges.
The default rounding entered will be used for any ranges not specified.
Trailing Zeroes
Set whether rounded areas should display any unnecessary zeroes following the decimal point.
Trailing zeroes are displayed if the check box is active. For example if the check box is not active
then 123.400 would display as 123.4
Show Decimal
Set whether the decimal point is to be shown for rounded areas which are a whole number of units and
have trailing zeroes not shown.
The decimal point is displayed if the check box is active. For example if the check box is not active,
then 123.000 would display as 123
OK
Save any changes made and return operation to the Configure Areas dialog box.
The changes may still be cancelled by selecting Cancel in the Configure Areas dialog box.
Cancel
Close the dialog box without saving any changes and return operation to the Configure Areas dialog
box.
Refer to the Area Rounding topic for further assistance and an example of how the rounding is applied.