Apply Transformation

(This functionality is available with the Transformations module)

The Co-ordinate / Apply Transformation command is used to apply the current co-ordinate based transformation to selected points. This command cannot be used until a transformation has been defined using the Co-ordinates / Define Transformation command or a previously saved transformation (.trp file) has been loaded using Transfomations / Co-ordinates / Load Transformation.

Apply Transformation dialog box

Command	Used to
Name:	Display the name of the current transformation. This will be a .trp file if the transformation was loaded using Transfomations / Co-ordinates / Load Transformation. If the current transformation has been defined using the Co-ordinates / Define Transformation command, the name will be generic "Conformal", "Affine", or "Semi-Affine" depending on the transformation type computed.
Point Range:	Key in or select a point range from the screen.
Apply in Reverse:	Select that the transformation is to be applied in reverse.
Move:	Apply the current transformation to the selected points. If a block is defined, points which are both defined by the block and by the point range are moved. If point range is blank, all points defined by the block are moved.