Create Point By Chainage & OffsetPoint by Chainage & Offset

(This functionality is available with the Computations module)

Creates a new point by chainage along an alignment and offset from that alignment.

To run this option, select the Create/Point command and the Method/Chainage & Offset command from the Computations task to display the relevant dialog box.

The point to be created will be given the attributes currently defined via the Attributes/Point command. You should use this command to set the required attributes before creating any points.

Create Point by Chainage & Offset dialog box

Item Used to
Point ID: Key in the point identifier of the point to be created.
The point identifier may also be determined by using the Next or Last buttons.
Alignments: Select the alignment, with reference to which, the point will be created.
Chainage or Distance: Enter the position along the alignment where the point is to be created.
The name of this field is dependant on what has been set as the Data Input By type in the Configure/Alignment dialog.
You may also snap to any point to have its chainage or distance returned to the field.
Offset: Enter the offset from the alignment at which the point will be created. The offset may be left (negative) or right (positive) of the alignment.
You may also snap to any point to have its offset returned to the field.
Elevation: Enter the elevation of the point to be created.
OK Create the point.
The point will be created using the identifier and values specified and with the attributes currently set in the Attributes/Point command.
Next Update the point identifier field to the next available unused point identifier greater than the point identifier currently shown.
Last Update the point identifier field to one greater than the highest point identifier in the data base.
Close Closes the dialog box.