Transfer Multiple Long Section Elevations into Plan

(This functionality is available with the Profiles and Design module)

Transfers the elevations along the selected long sections on to existing points in those long section's control lines.

The Transfer Multiple Long Section Elevations to Plan dialog can be accessed from the Section Manager File / Transfer Multiple Long Section Elevations to Plan.

Transfer Multiple Long Section Elevations to Plan dialog

Item	Used to
Long Section	Select the long sections to have their elevations transferred to the plan view.
Make Points Contourable	Check if the points are to be made contourable
Make Planimetric Lines	Check if the line(s) are to be made into planimetric line(s).
Make Hard Break Lines	Check if the line(s) are to be made into hard break line(s).
Make Soft Break Lines	Check if the line(s) are to be made into soft break line(s).
Retain	Do not change the attributes of the points or the line(s).
OK	Transfer the long section elevations into the plan view.
Close	Close the dialog box.

Note

The line attributes selected may not always be possible. For example, if a long section does not extend along the whole length of a line, and there are 2D points already in that line, then it will not be possible to make that line a breakline.

Only one long section for each control line may be selected. If multiple long sections are selected from the same control line a list of the control lines, and the long sections that reference them will be displayed.