Delete Points

(This functionality is available with the Computations module and the 3D Visualisation module)

Allows the deletion of existing points.

The Edit/Delete/Points command is selected from the Computations Task or the 3D Visualisation module.

You may then use the Delete Points dialog box.

Snap to and accept an existing point to have it deleted.

Alternatively click in the Point identifier field and key in the identifier of the point to be deleted followed by an Enter key or a click on the Delete button. Note that keying in two point identifiers separated by .. will delete a range of points. For example, 10..15 would result in points 10 to 15 being deleted.

Notes:

If a Block is active, then clicking the Delete button will delete those points which are both defined by the block, and nominated in the Points field. If the Points field is blank, then all points defined by the block will be deleted.

Selecting the 'Planimetric Only' check box will limit the points that can be selected for deletion to non contourable points.

Click the Close button to exit the command.